i617 rogers blackjack 2 issues reading port to get codes [Waiting for user]
I have the proper drivers and the comport is seen but i cant get the unlock codes or get srs to unlock my phone. What am i doing wrong?
Please provide us some more info so we can help you.
What is your SRS Username ?
What error you get ?
What cable you use for unlocking ?
My username is SRS025478, I am using the cable that came with my phone and the error I am getting is as follows:
Communication Error: PCOM001
- Wrong port selected. (press RESCAN)
- Samsung Drivers not installed
- Phone not in PC-Studio mode
Also check when your using a serial cable, if there is an connector for a 9 volt battery on the cable, in that case you MUST connect the battery to the cable (red/black wire with clip)
-- Operation done in 19 seconds -- Detected COM4 - STATUS: Ready (DIAG)
Remark: Sometimes the modemport is not detected correctly, then you have to set this port manually
-- Operation done in 61 seconds --
for unlocking the I617 you need an special cable as also instructed on the website:
[ Login above or register to see download links. ]
I didn't need a special cable. There was a setting for debugging in the service mode that had to be turned off. I found the information by looking at other issues with the same error. Although my service menus are different from the resolution I found I was able to apply the solution and my phone was unlocked a few minutes later. Thanks!!! Now I just need a dl site for windows mobile to upgrade it.
can you tell me what you did to enable the diag options ?
then we also implement this information in the software.