Bircked Galaxy Pro

[Quad]

There is not much info about galaxy pro on the internet, so let this thread be an help topic for everyone facing such problems.

---

Hello,

While flashing phone, i accidentally disconnected the cable from my PC, then of course immediately odin showed red FAIL.

Right now, i can not boot the phone with power button, nor with any of the key combinations i know. Nothing comes up in the screen, as if i am not pressing any buttons at all. Phone also does not show the charging indicator when it's connected to the charger.

BUT, if remove sim,sd and battery then connect it to pc and put battery while holding VOL DOWN+(one of the Q / E / T)+POWER and put battery in pc recognizes it as a device(3 devices), and ODIN turns yellow.

When i select ops the title changes to ODIN MULTIDOWNLADER (GT-B7510). But when i try to flash, it gets stuck on "<1 > setup connection".


I am not keeping my hopes up, if anyone has suggestions to my problem, i would love to hear them.

I am going to try 301k OHM JIG this afternoon when the resistors arrive, but afaik that works for galaxy s series.

[Morfious_matrix]

maybe a wipe data and cache before trying to flash a new firmware would help, give it a try

[Quad]

Yes, that could help.

But as i said, let alone booting up normally, i can't boot the phone in neither download mode or recovery mode. In all the process i explained above there is nothing in the screen.

[Quad]

Tried jig, but turns out battery is dead, i will find some way to charge it and then try the jig again.

[Quad]

If anyone interested after fiddling with a rheostat for a night i found out you need a 208k ohm resistance on 4th and 5th pin.301k for galaxy s ones does not work.